I remember the last period, Xiao Bian analyzed the knowledge of step drill, Xiao Bian today will once again for everyone to explain the knowledge step drill. We hope that through Xiaobian introduction, you can drill the contents of the steps have a certain understanding and understanding of the following to look at the relevant introduction to it:

The stepped drill is one of the products produced by our precision drilling tool manufacturer. It is made of hard alloy material. It is mainly used for machining the hole in the steps. It can improve the processing efficiency in one time and can make various specifications according to the customer's request. . When the drill is stuck, it is necessary to turn off the motor immediately. When the drill is stuck, it is necessary to turn off the motor. When the step drill is jammed, the motor needs to be turned off immediately. In this case, When stepping the drill, do not touch it. When replacing the drill, make sure that the power supply of the device is disconnected. In addition, our operators need to be noted that the edge of the drill bit is relatively hard, not good storage, need careful protection.

In summary, the operator on the use of step drill should pay attention to the problem, Xiaobian to explain here, the pro who have any good suggestions, you can consult Xiaobian Oh.